Hydraulic vane pump V10-1P7P-38C20L instruction manual
1. Product Overview
Hydraulic vane pump V10-1P7P-38C20L is a high-performance, high-reliability hydraulic power unit designed for pressure transmission and flow control in industrial hydraulic systems. This quantitative vane pump adopts advanced vane pump technology combined with precision manufacturing technology to ensure stable operation under high pressure, high speed and harsh working conditions. With its excellent performance, compact structure and easy maintenance, the V10 series is widely used in engineering machinery, machine tools, metallurgy, shipbuilding, petrochemical and other fields.
2. Product Specifications
Model: V10-1P7P-38C20L
Type: Hydraulic vane pump
Displacement: Depends on the specific model, usually suitable for medium to large flow requirements
Maximum working pressure: Depending on the specific configuration, it can reach a higher pressure range (please refer to the product manual for specific values)
Speed range: Suitable for a variety of speed conditions, please refer to the product technical parameter table
Medium: Hydraulic oil (must meet the specified viscosity, cleanliness and other requirements)
Structural features: built-in pressure regulator (if applicable), wear-resistant blades and bearing design
3. Installation and debugging
Preparation before installation:
Make sure the hydraulic system is thoroughly clean and free of impurities and residues.
Check whether the installation foundation of the hydraulic oil pump is flat, stable and meets the installation requirements.
Prepare necessary installation tools and accessories.
Installation steps:
Follow the installation instructions in the product drawings or instructions to correctly install the pump body, drive device and connecting pipes.
Make sure all connections are tight and secure with no risk of leakage.
Before connecting to the power supply or power source, check the electrical connections and safety devices again.
Debugging and trial operation:
Start the pump without load and check whether it runs smoothly and without abnormal noise or vibration.
Gradually load to the rated working pressure, observe the performance of the pump, and record the relevant parameters.
Adjust settings such as pressure and flow to ensure that the system meets design requirements.
4. Operation and Maintenance
Operation Notes:
Check the oil level regularly and keep the hydraulic oil within the specified range.
Avoid running the pump for a long time in no-load or overload state.
Check oil temperature regularly to prevent overheating which can cause performance degradation or damage.
Maintenance:
Replace the hydraulic oil regularly to keep the oil clean.
Regularly check the pump's seals, bearings and other wearing parts, and replace worn parts in time.
Clean the outside of the pump body to maintain good heat dissipation.
Check the electrical system regularly to ensure that the wiring is secure and there are no short circuits or open circuits.
5. Troubleshooting
If the pump body heats up, the noise increases, the pressure is unstable, and other abnormal conditions occur during use, the machine should be stopped immediately for inspection. Common faults may include oil contamination, seal failure, bearing wear, etc. Take appropriate maintenance measures according to the specific situation. If necessary, contact the technical engineer of Guangdong Yihe Hydraulic Technology Co., Ltd. for professional maintenance.