T6D(*) series single pump performance characteristics:
1. High working pressure - the rated working pressure is as high as 275 bar, which can reduce the size of hydraulic actuators, hydraulic control valves and piping, reducing installation costs. If used with lower working pressure, the working life can be extended;
2. High volumetric efficiency - the typical volumetric efficiency is 0.94, which has high volumetric efficiency even under loading, which can improve productivity, reduce heat generation and reduce the operating cost of hydraulic equipment, and allow full pressure conditions The rotation speed is as low as 600 rpm (the vehicle pump can even be as low as 400 rpm);
3. High mechanical efficiency - typical value is 0.94, which reduces energy loss;
4. Wide speed range - the speed range is 600 ~ 2800 rpm (vehicle pump is 400 ~ 2800 rpm). Combined with the installation of large displacement pump core components in a small size casing, the working condition can be optimized and noise reduced. ;
5. Low speed (600 rpm, 400 rpm for vehicle pumps), low pressure and high viscosity (860 cSt, 2000 cSt for vehicle pumps) operating capabilities - enabling the T6 series vane pumps to adapt to low temperature conditions and reduce power consumption Small and no risk of sticking;
6. The pressure pulsation is small - about ±2 bar, which can reduce the noise of the hydraulic pipeline and extend the service life of other components in the hydraulic circuit;
7. Low noise - improves work safety and increases acceptance;
8. Strong anti-pollution ability - this series of pumps adopt double-lip structure blades, which have extremely strong anti-pollution ability and long service life;
9. A wide range of optional structural parameters and forms - such as: pump core displacement, drive shaft form, oil port configuration, etc., making it easy for users to choose according to installation needs;
10. Diversity of installation forms - there are 32 installation combinations for double vane pumps, and up to 128 installation combinations for triple pumps, which can reduce costs and improve performance;
11. Wide applicability - The installation method complies with the 2-hole flange form specified by SAE J744a and ISO 3019-1, and is equipped with various flat key and spline transmission shafts for selection. For vehicle-type pumps, there is also a T-shaped drive shaft (complying with SAE J718c) option, allowing it to be directly assembled with the tractor (speed 540 ~ 1000 rpm);
12. Double shaft seal option - the vehicle pump has a double shaft seal type (T6*P type), with a drain port, which can be directly installed on the gearbox.