T6DC, T6DCM, T6DDS series double vane pump installation dimensions instructions

2024-03-08



High working pressure - rated working pressure up to 275 bar, which can reduce the size of hydraulic actuators, hydraulic control valves and piping, reducing installation costs. If used with lower working pressure, the working life can be extended;

High volumetric efficiency - the typical volumetric efficiency is 0.94, which has a high volumetric efficiency even under loading, which can increase productivity, reduce heat and reduce the operating cost of hydraulic equipment, and allow the rotation speed under full pressure conditions As low as 600 rpm (vehicle pump can be as low as 400 rpm);

High mechanical efficiency - typical value is 0.94, reducing energy loss;

Wide speed range - the speed range is 600 ~ 2800 rpm (vehicle pump is 400 ~ 2800 rpm). Combined with the installation of large displacement pump core components in a small size casing, the working condition can be optimized and noise reduced;

Low speed (600 rpm, 400 rpm for automotive pumps), low pressure and high viscosity (860 cSt, 2000 cSt for automotive pumps) operating capabilities - the T6 series vane pumps can adapt to low temperature conditions, with low power consumption and No risk of jamming;

The pressure pulsation is small - about ±2 bar, which can reduce the noise of the hydraulic pipeline and extend the service life of other components in the hydraulic circuit;

Low noise - improves work safety and increases acceptance.

Strong anti-pollution ability - This series of pumps adopt double-lip structure blades, which have strong anti-pollution ability and long service life;

The optional structural parameters and forms are rich - such as: pump core displacement, transmission shaft form, oil port configuration, etc., making it easy for users to choose according to installation needs;

Mounting versatility - 32 mounting combinations for double vane pumps and up to 128 mounting combinations for triple vane pumps, reducing costs and increasing performance.

Wide range of applicability - Mounting conforms to 2-hole flange style specified by SAE J744a and ISO 3019-1, and comes with a variety of flat key and splined drive shaft options. For vehicle-type pumps, there is also a T-shaped drive shaft (complying with SAE J718c) option, allowing it to be directly assembled with the tractor (speed 540 ~ 1000 rpm);

Dual shaft seal option - the automotive pump has a dual shaft seal version (T6*P type) with a drain port that can be installed directly on the gearbox.

 

General instructions for use:

1. Check the pump's steering, speed range, pressure, temperature, oil quality and viscosity;

2. Check whether the suction port condition of the pump meets the usage requirements;

3. Check the transmission shaft type and whether the torque meets the working condition requirements;

4. Select an appropriate coupling to minimize the radial load of the pump (caused by weight, non-axial deviation, etc.);

5. Filtration: Must meet the requirements of the minimum pollution level;

6. Working environment: avoid the influence of noise, pollution and impact

 

T6DC, T6DCM vane pump installation dimensions:

T6DDS vane pump installation dimensions:


Get the latest price? We'll respond as soon as possible(within 12 hours)