T6/T7 series single, double and triple vane pump models

Advantages of T6/T7 series single, double and triple vane pumps:

This type of vane pump is mainly designed for high/low pressure hydraulic circuits. It uses a combination of pump cores of different specifications in a double or triple pump to meet the requirements of high pressure (up to 300 bar) small flow and low pressure large flow conditions. This is a smart way to optimize your loop design.

This type of vane pump can meet very rapid pressure change cycle requirements, the output flow can maintain precise repeatability, and has the following advantages:

●High working pressure: The maximum pressure of the small-sized casing pump can reach 320 bar, which can reduce the installation cost. If used at reduced pressure, the working life can be extended;

●High volumetric efficiency: the typical value is higher than 94%, thus reducing heat generation and allowing the rotation speed to be as low as 600 rpm under full pressure conditions;

●High mechanical efficiency: typical value is higher than 94%, reducing power loss;

●Wide speed range (600rpm~3600rpm): Combined with the use of a large-displacement pump core, a smaller-sized housing can be used to form a larger-displacement, low-noise pump;

●Low speed (600 pm), low pressure and high viscosity (860 cSt) working performance: allows operation under low temperature conditions, with low energy consumption and no risk of stuck;

●Small pressure pulsation (±2 bar): reduces pipeline noise and extends the service life of other components in the circuit;

●Strong ability to resist solid particle pollution: This is the effect of using double-edged blade technology, and the pump has a long service life;

●Various installation and structure options (pump core displacement, drive shaft type, oil port configuration, etc.): easy for users to use;

●The concept of pump core components: doubles the maintenance cost;

●Note: Special designs can be provided to optimize the noise characteristics of the pump.

T6/T7 series single, double and triple vane pump displacement specification range:

B series: 5.8 to 50.0 m/rev;

C series: 10.8 to 100.0 m/rev (T6 series);

D series: 44.0 to 158.0 m/rev;

E series: 132.3 to 268.7 m/rev.

T6/T7 series single, double and triple vane pump working pressure:

B series: up to 320 bar (300 bar for multi-unit pump);

C series: up to 275 bar;

D series: up to 280bar (250bar for multi-unit pumps);

E series: up to 240bar.

T6/T7 series single, double and triple vane pump speed range:

Industrial pump: 600~3600 rpm