Installation dimensions of T6EC, T6ED, T6EE series double vane pumps

T6EC, T6ED, T6EE series double vane pumps have the following advantages:

High operating pressure - Rated operating pressure up to 275 bar, allowing the size of hydraulic actuators, hydraulic control valves and piping to be reduced, reducing installation costs. If used with lower working pressure, the working life can be extended;

High volumetric efficiency - the typical volumetric efficiency is 0.94, which has a high volumetric efficiency even under loading, which can increase productivity, reduce heat and reduce the operating cost of hydraulic equipment, and allow the rotation speed under full pressure conditions As low as 600 rpm (vehicle pump can be as low as 400 rpm);

High mechanical efficiency - typical value is 0.94, reducing energy loss;

Wide speed range - the speed range is 600 ~ 2800 rpm (vehicle pump is 400 ~ 2800 rpm). Combined with the installation of large displacement pump core components in a small size casing, the working condition can be optimized and noise reduced;

Wide speed range - the speed range is 600 ~ 2800 rpm (vehicle pump is 400 ~ 2800 rpm). Combined with the installation of large displacement pump core components in a small size casing, the working condition can be optimized and noise reduced;

The pressure pulsation is small - about ±2 bar, which can reduce the noise of the hydraulic pipeline and extend the service life of other components in the hydraulic circuit;

Low noise - improves work safety and increases acceptance.

Strong anti-pollution ability - this series of pumps adopt double-lip structure blades, which have strong anti-pollution ability and long service life;

The optional structural parameters and forms are rich - such as: pump core displacement, drive shaft form, oil port configuration, etc., making it easy for users to choose according to installation needs;

Mounting versatility - 32 mounting combinations for double pumps and up to 128 mounting combinations for triple pumps, reducing costs and increasing performance.

Versatility - Mounting conforms to 2-hole flange formats per SAE J744a and ISO 3019-1, and comes with a variety of keyed and splined drive shaft options. For vehicle-type pumps, there is also a T-shaped drive shaft (complying with SAE J718c) option, allowing it to be directly assembled with the tractor (speed 540 ~ 1000 rpm);

Dual shaft seal option - Automotive pumps have a dual shaft seal version (T6*P type) with a drain port that can be mounted directly to the gearbox.

General instructions for use:

1.the pump's steering, speed range, pressure, temperature, oil quality and viscosity;

2.Check whether the suction port condition of the pump meets the usage requirements;

3.Check the type of drive shaft and whether the torque meets the working condition requirements;

4.Select an appropriate coupling to minimize the radial load of the pump (caused by weight, non-axial deviation, etc.);

5.Filtration: Must meet the requirements of the minimum pollution level;

6.Working environment: Avoid noise, pollution and impact.